Search results

  1. 9

    Tuning Questions(s Trim)

    hello all, Been out of the car game for awhile. Wondering what my options are as far as tuning. Currently have a mild 306 with s trim and c4. Looking to get it professionally tuned this time around. What is everyone using. Shops around here seem to like sct. I have a Anderson pms that is...
  2. 9

    Help With Fuel System Selection(boosted)

    Been away from the scene for awhile and trying to get my car dialed in. Currently it has an s trim pushing about 10psi (for now) with an Anderson mr Freeze kit. Other mods are fresh 306 with strike force cylinder heads, anderson b-31 cam, 80mm mass air, and 65mm throttle body. Current fuel...
  3. 9

    Fuel leak? Can someone explain an efi fuel tank to me?

    I recently noticed a fuel leak while running my car. The leak is coming from somewhere in the fuel pump area. I dropped the tank today to explore but I could not narrow down where it is originating from. The entire top of the fuel pump area was soaked. Lines were dry and tight. The only...
  4. 9

    Overspinning alternator??

    While driving my car yesterday I noticed that on the highway while travelling about 3500rpms (c4 with 3.73) my battery light comes on and the volt gauge shows around 18volts. If I let off the light goes off rather quickly and volts bump down to between 14 to 16. I am pretty sure this just...
  5. 9

    Whats the weak link in my cooling system??

    I finally got the car running after a two year break. My problem is now is that it wants to heat up while driving. At idle it will sit at 190 all day in 105 degree weather. However once you start getting on it it will quickly creep towards the 250 mark. If I back off and drive very easy it...
  6. 9

    c4/auto trans question???

    I recently rebuilt a c4 and am getting ready to drop it in with my new motor. I have bolted everything together, but when I went to spin the crank by hand i cant find neutral while clicking through the gears. My question is should I be able to find neutal or does the motor have to be running...
  7. 9

    ?? Use level 20, or stock block ??

    Here is my dilemma, I have both and am getting ready to a rebuild. I know the level 20 is a stock block and it can be level 10,000000, but its still stock. Who has the level 20 and what are you getting out of it. Has anybody on here put the claims to the test? I picked it up for a good price...
  8. 9

    Will .040 milled heads bump compression too much for supercharger

    I am looking at a new set of heads for a rebuild. Block will be built to stock specs with forged internals and anderson b-31 cam. Would a set of heads milled . 040 bump compression to high?
  9. 9

    Where to hook up pcv valve on typhoon intake?

    Just installed typhoon intake and need to know where you guys connected the pcv valve up to on the upper. I thought it would not matter which port, however since I installed the intake I am getting steam coming from the breather on the valve cover. Thxs
  10. 9

    Is this theory correct? Vacuum related

    Still chasing down vacuum problems. Today what I did was cap of all ports on the vacuum tree except the one for the intake, also capped of 1 of the lines on the back of the upper intake, hooked the gauge up to the other then ran the car. I am still getting the same vacuum reading. By...
  11. 9

    Balancer alignment??

    Anybody got a balancer around they can look at for me? I need to know where the key way on the inside of the hub aligns to the outside marks. I think mine may have spun. The rubber is starting to come out of it. Thxs:flag:
  12. 9

    Very low vacuum, decent idle.

    I put my car back together after changing out headgaskets. Now car will start and idle but there is very little vacuum, 3-5. It revs fine and idles fairly smooth. Car is also very rich, eye watering rich. I tried the card cleaner trick and found my pvc hose on the lower was a little loose...
  13. 9

    Compression #'s not good, help diagnose please!

    Did a compression check today after finding water in my oil.(milkshake). 1 160 2 170 3 165 4 155 5 150 6 95 7 65 8 105 I just installed new copper gaskets after blowing my stock type under boost. Actually I...
  14. 9

    How many oil changes after head gasket install??

    How many oil changes did it take you guys after installing new headgaskets to get rid of all the coolant/water?. I am on 3 and still have the milkshake. Im leaning towards something else may be messed up. Doing compression test on Sun.
  15. 9

    Car wont start, sounds like bubbling in exhaust??

    I replaced the headgaskets obn my car. Reassembled everything and fired the car up. The car ran like ***** and heated up very quicky. After searching on here and speaking with some people I figured the distributor was 180 out. Here is what I did lined it back up to 0 on the balancer and #1...
  16. 9

    starter wont stop spinning and more...

    :shrug: Been have a bunch of problems with the car lately. The latest the starter wont stop spinning, and now the car has no power at all and wont take a jump start. All I have to do is turn the battery switch on and the starter starts running. Heres what i did so far after searchng through...
  17. 9

    Electrical/Starting problem

    Having some problems starting my stang at times. When I go to start it, it seems that all the sudden all power dies. I can turn the key all the way to start and all is fine without the clutch pressed but as soon as I push to push the clutch in and turn the key all the lights dim, the...
  18. 9

    installing circuit breaker as anti theft device with battery relocation

    I know I saw this on here before, I relocated my battery using buffhomers install directions and I remember seeing on here where someone installed a circuit breaker somewhere within the wiring to act as a anti theft device. This was in addition to the cut-off switch.
  19. 9

    Fuse/Circuit Breaker for Battery Relocation

    Finishing up with my battery relocation and came up with a question. I am using a 120a circuit breaker for the power wire off the alternator. I went to the local car audio store for a junction block to connect the alternator wire(stock alternator), basicly wanted the junction block for a...
  20. 9

    Need t5 tranny part in MD ASAP

    Anybody have any t5s laying around I need a neutral sensing switch that plugs into the top of the tranny. Nobody has or can get these. Let me know thanks Ricky
Top Bottom
Back
Forums
Menu