Search results

  1. F

    What would cause this?

    I have a plug wire dilemma and am confused, I purchased a set of Ford Racing wires and have had them a total of maybe two months. Anyway they don't exactly burn but have developed a blister on the plug side that you can push your finger through and its really mushy. this is on every boot. I am...
  2. F

    gauge install problems

    I installed some Autometer gauges in a friends car and the water temp and the oil pressure gauge do not register anything at all. They are electrical and first the oil gauge, it came with a sender and according to the instructions requires one wire to send a signal and has a ground and 12volt...
  3. F

    Subaru people?

    I have an 88 GL with a 1.8l in it and here is the problem. I was heading to work and as I toped this hill by my house the car dies and now it will not start. I have fuel and unsure of spark. what are the odds of coil going bad? Anyway it turns over and that is all I can check at this point it...
  4. F

    DC Control still around?

    I am tired of trying to figure out why the low speed fan does not work so I am going to eliminate the computer from the scenario and tried to look up DC Control and get nothing. Are they gone? I am considering the Flex a Lite VSC as well but only second to th DC Control.
  5. F

    what does a ccrm cost?

    I beleive my ccrm is dead and would like to know what others have paid for a replacement. I can unplug the ect sensor and the fan comes on. If I turn on any of the AC settings I get nothing from the fan. If I drive around the car will get warm enough that I dont want to drive it. I also do not...
  6. F

    Stumbles at 3000rpm

    I have been chasing a gremlin for a while now and here is what I have come up with. While monitoring the voltage on my TPS it will go from below 1 volt and as it hits three volts while opening throttle it will blank out and show nothing until i pass this point. I am thinking there should not be...
  7. F

    company stands behind it product!

    Today I got my brand new replacement radiator from Fluidyne. I had read on a few of these sites how they did not back there product and after discovering the dreaded leak on the ends I figured the worst. I sent it back and awaited evaluation expecting them to do a repair job to get it through...
  8. F

    screw size for tfi module

    Any one know what size the screws are for the fti module .
  9. F

    EGR tube and Mac headers

    I bought Mac headers and installed them back when I did my HCI setup and at that time spaced intake 3/8" and bought the extension nut for the egr tube. When it came time to install the tube it would not fit due to Mac locating the fitting on a different header tube than OEM. With the adaptor and...
  10. F

    Got my boost back!!!!!

    Finally after the dumb drunk in the Honda landed on my LX I am back in the boost game again. Just finished the install of my V2-SQ and everything is right in the world again. Something about the whistle and the power but I will need to wait on the rain to really give it a good run.
  11. F

    High mount brake light on Cobra?

    Mine does not work and I dont see anybody selling anything like replacement bulbs or anything. Does anybody sell this or am I out of luck.
  12. F

    fuel rail mounted guege?

    I had an electric fuel pressure guage on my 93' lx and used a fitting that screwed into the schreader valve. I figured that same fitting would work on my 94' Cobra. The fitting has a 1/16"-27 male npt fitting and a 1/8"-27 female npt fitting. The male end is the same size as the outside...
  13. F

    camshaft dowel length?

    How much should the dowel stick out from the end of Camshaft. I believe I need to grind some off or the pin will stick to far out when the timing chain is installed. I dont believe I will get out the one that is already in there.
  14. F

    Are these headers Junk?

    I have some BBK headers with the ceramic coating. The Previous owner of my Cobra put these on and for what ever reason could not get them to seal at the collector, so large amounts of washers were used to get them tight (I am just guessing). Anyway I broke the collector studs trying to get them...
  15. F

    24's enough?

    24lb injectors should be enough for 94' Cobra with Twisted Wedge heads, stage one cam, Tmoss ported lower Cobra intake (or Street heat intake) with 65mm throttle body? I have 30's from my old car but would need a calibrated mass air. Should be ordering the misc. parts as soon as intake decision...
  16. F

    94 Cobra or 93'

    I have a 94 Cobra and I am debating getting rid of it for a 93 notch at a dealership locally. The notch has trickflow heads and b303 cam and some other mods not listed. Assuming everything checks out and notch is a decent car I am probably still going to be left undecided what would my fellow...
  17. F

    Bear Decelarotors?

    Any good word on these?
  18. F

    Intake for twisted wedge heads?

    I had the whole tfs kit and when I bought my Cobra figured I would keep the Cobra intake and use it with the kit. Sold the tfs intake and since have heard the Cobra lower will not fit up very well with the Twisted wedge heads. The intake needs to be spaced up a half inch and so on. What intake...
  19. F

    Rear window defrost?

    On the driver side the little connection on the glass has been pulled away. Can I just resolder that or is there a better way to fix it?
  20. F

    Foxbody catback on 94 cobra

    I have and old Mac flowpath catback off my 93" lx I am curious as to wether it will fit on my Cobra. I have noticed alot of the Mac adds list the catback as 87-93lx or 94-95GT
Top Bottom
Back
Forums
Menu