Looks good! Where did you get those valve cover studs? I would love to be done with trying to line the valve cover and gasket up with the holes while trying to put the bolts in.
Looks pretty similar to my engine build. Keep the updates coming!
Interesting way to route the pipes but IMO the airpath is way to long, and to many hard bends.... How hard are you going to spin the Novi?? Your actually going to pick up a lot of heat from the pipe being that close to the header, it will increase the air temp a good bit.
I tried a few set-ups when I custom built a set-up for a SN series car using a V2 SQ, picked up quite a bit by changing the pipes around, the less bends the better...
Can you use the upper pointing either direction?
Looks good though
Interesting way to route the pipes but IMO the airpath is way to long, and to many hard bends.... How hard are you going to spin the Novi?? Your actually going to pick up a lot of heat from the pipe being that close to the header, it will increase the air temp a good bit.
I tried a few set-ups when I custom built a set-up for a SN series car using a V2 SQ, picked up quite a bit by changing the pipes around, the less bends the better...
Can you use the upper pointing either direction?
Looks good though
I agree, I think an intercooler with both the inlet and the outlet on the same side would help to remedy that problem. Just my .02, and just something to think about. The build looks awesome though, can't wait to see it when its all done.