wanted: b303 dyno sheets

[rsw007]

i need to see where your peak hp is. and did yuo install cam straight up?

 

[GTOreturns]

RSW did you blow that thing up yet?

 

[rsw007]

nope installed gt40 iron heads 1.72 rockers and hand ported stock lower and went 11.23@117 with the same 125shot. now im looking for a way too pull up top more so i can make it to the 10's

 

[GTOreturns]

nope installed gt40 iron heads 1.72 rockers and hand ported stock lower and went 11.23@117 with the same 125shot. now im looking for a way too pull up top more so i can make it to the 10's

That's gott be some kind of record. Do you have a cage? I can't believe it's the stock short block! No new bearings or rings installed?

 

[GT_Rich]

Installed straight up. Everything you should need to know about my setup is in my sig.

The two dyno runs shown are before tune and after tune.

 

[rsw007]

thanks rich, anyone else? i know theres alot of b cams out there.

 

[stykthyn]

why do you want peak hp? hp across the band would be better.

 

[rsw007]

cause on the spray im trapping 5800rpms and i know the stock cam is done there. and the nitrous has plenty of torque down low and through the mid range. i just installed some 1.72 rockers i got so i need a cam that i can use with them. tfs stage 1 would be too much lift like .548 ouch. i think the crane springs that cam on the 93 cobra are only good till about .525-.530. i heard the b303 is strong on the exhaust side which will help with the nitrous.

 

[PUNISHER RACING]

the E cam works pretty good with a power adder also, or a better power adder cam that will give you more top end and use your 1.6's

 

[rsw007]

keep them coming guys. help me get this aod car in the tens