4.6l

Hello all, I have a full set of hoses for a 3V 4.6L V8 for factory years 2005 - 2010 Ford Mustang GT. These are brand new hoses all genuine Ford parts. Asking $275 + shipping for all. I paid over $320 for these from what I remember. Please see photos attached.

Hi kids. Longtime listener, first time caller. So I bought a 2000 Mustang GT. Auto car. 203xxx miles. The previous owner said it's had the crank sensor, cam sensor, throttle position sensor, fuel pump, fuel filter, battery, brakes, complete stereo system, all of suspension bushings, tie rods...

I spent several hours searching without luck for the 42-pin C210 engine harness pinout without luck. Since I ultimately had to trace each wire by hand I decided I would document my work for future reference and post it if anyone else needs it. I have a new edge harness I will also trace when I...

I'm trying to sell this Vortech Supercharger Kit for my boss that was bought for her Exhusband's 2002 4.6L Mustang GT. I have more pictures and I will do my best to answer questions. This system is Brand New I only unboxed and unwrapped to sell it. She's asking $4,500 OBO I'm located in...

Hello, I am 17 years old an currently own a 2008 Ford Mustang V6. I can't afford the insurance on a GT :cry: so.. I have been pouring money into this V6 to make it look as good as possible. (Photo will be provided at the end.) Of all the mods I have done, I think it's time for a little more...

1998 Ford Mustang GT (startup after 9 years) The engine started right up, and as I watched the engine after it had started, Light brown oil (obviously mixed with coolant) started to flow very quickly out of my resivoir. Also, I found that the oil and coolant mix was found everywhere in the...

Is there a common area to troubleshoot for surging or bucking under load? When I say surge/buck it feels like the engine is briefly losing power and then back to normal but this symptom is occuring 3-4 times per second under the right conditions. for example when on the freeway in 5th gear I...

Sup guys. 1st post, don't hate. I finally had to take to actually asking the forums. First off this isn't the regular No comm issue. I've done as much research as I can and can't find anything to help. I went to smog at a local shop. Nearly nothing has changed since my last smog. I go in...

So I had to drop a new motor into my 2000 mustang gt. The engine is from a 2005 crown victoria. The engine ran perfect when we got it. We got it into the mustang and hooked everything up but now when we started it, it idles at 700 rpm then will jump to about 2000 rpm and will stay there. If we...

Hello everyone my name is Kenneth. I've been trying to find a trustworthy engine shop here in Las Vegas/Henderson but haven't had much luck. I was wondering if anyone could point me in the right direction?

Hey guys, I just bought a 96 gt... It's my 1st mustang and I'm a huge fan. Also, I'm very knowledgeable with them as well. Just want opinions on some bolt ons. Just purchased a bbk cold air intake as well as the 78mm throttle body/ plenum combo. Car came with heads as well from an 04, which are...

Hey guys, I just bought a 96 gt... It's my 1st mustang and I'm a huge fan. Also, I'm very knowledgeable with them as well. Just want opinions on some bolt ons. Just purchased a bbk cold air intake as well as the 78mm throttle body/ plenum combo. Car came with heads as well from an 04, which are...

I have a 98 gt convertible and the rear driver side window will now go down nor up.. All other 3 windows work fine. (power windows). I checked the back of the switch to make sure all wires were connected and they were and looked fine. Any help is appreciated.

I drive an '01 GT auto. Heads, cams, cai, intake/plenum, and nitrous. Currently have 3.73's, but I've been looking into getting 4.10's. I plan on going to the strip at some point, it'd be a fun time for my dad and I (I'm 16, we're both Mustang guys) and we'd settle our debate about our cars(he...