I have been busy working in the shop and I need to update
I block sanded the fiberglass hood
Sprayed one coat of SPI black epoxy
Two Coats of SPI Turbo primer
Block sanded again
Two coats of SPI epoxy
The fiberglass bumper did not fit our car. The center section did not line up with the lower valance and the bumper was to narrow.
I cut the center out of the bumper and had to modify the holes in the taillight panel to get the bumper lowered.
I used Duraglass to attach the brackets to the bumper. Later I added a couple layers of fiberglass to hold them in place
This shows you have much I need to add to the left side
I added fiberglass to the top to hold it in place
I clamped it to a long piece of angle and added fiberglass on the back side.
I removed the braces and clamps and finished adding fiberglass to both sides and this is how it looks now. I still have to work on the gaps.