Picture of the bypass valve / manifold pressure-vacuum / trim?

[Xcessiv]

Hi guys,

I'm installing a V2 on my car and I'm not 100% sure of how to prepare the bypass/manifold/trimming assembly. It's on a 4" powerpipe by the way.

I used the 90 degrees plastic fitting instead of the straight one for better clearance (pointing downward), is it ok?

Where is the manifold/pressure vacuum located?

Thanks.

 

[AmBo]

Ex-squeez me? pics?

 

[Xcessiv]

http://www.vortechsuperchargers.com/pdf/manuals/4FH4FL218im.pdf

On page 23 (or 35/40 according to the PDF doc), fig. 10-d.

Look at the bypass valve picture, where am I supposed to plug the small vacuum on the right side?

 

[AmBo]

http://www.vortechsuperchargers.com/pdf/manuals/4FH4FL218im.pdf

On page 23 (or 35/40 according to the PDF doc), fig. 10-d.

Look at the bypass valve picture, where am I supposed to plug the small vacuum on the right side?

Look at step 11.1-e. If I recall correctly (and I think I am) that just goes to any vac line you have laying around. They should give you a splice to splice (or "T") into the FMU vac line. All this does is make sure that you blowby when you're <0 psi vac and once you're in boost to not blowby.

If I'm wrong, someone please pwn me.