Don't forget to heat the fenders lightly with a heat gun. Helps.The tool came in last night. It's pretty heavy duty for only $40. I'll get some pics along with some progress pics tonight.
Even when I'm pre paint?Don't forget to heat the fenders lightly with a heat gun. Helps.
Even when I'm pre paint?
I'm against rolling, but only because it's one of those things you can't undo easily. I just prefer to avoid it if I can
I did the same, used it and sold it for $40 on Facebook lolSo yeah...ended up ordering one of these to roll my rear fenders. Down to $25 or so on eBay now. Doesn't seem like much profit to be had after shipping
I remember when this tool was expensive enough guys were charging rental fees to borrow one.
I did the same, used it and sold it for $40 on Facebook lol
Are you using a heat gun to heat it up and then rolling? I’ve been thinking about doing it vs taking it some whereOk. Started the drivers side. Spent about an hour on it. About half of that was figuring out the tool. It came disassembled and with no instructions. Took me a few tries to figure where the big cotter pin went. But the tool worked really well.... so well that I didn't think it was working at first. It rolls the lip without any movement in the quarter panel at all. I'll work it a little more but so far I'm impressed for the $39 I spent. Good thing I needed one more pass of primer.