Some help needed again...
My stock single exhaust at the rear bumper had the one into two pipe.
I am installing new dual exhaust and purchased these rear tail pipe hangars
My existing bolt holes,in the frame, for the bracket, are sideways ( more side to side, not up and down) and I assumed these new brackets went vertical ( the bolt hole down with the bent part sliding into the hole on top)... Is my assumption incorrect and Do these fit " sideways" like the holes in the frame are now?
Hope I am making sense here...
The pass side has NO holes for a tailpipe hanger, I didn't expect any but I want to get one side correct before i start drilling...
thanks for any help here...
My stock single exhaust at the rear bumper had the one into two pipe.
I am installing new dual exhaust and purchased these rear tail pipe hangars
My existing bolt holes,in the frame, for the bracket, are sideways ( more side to side, not up and down) and I assumed these new brackets went vertical ( the bolt hole down with the bent part sliding into the hole on top)... Is my assumption incorrect and Do these fit " sideways" like the holes in the frame are now?
Hope I am making sense here...
The pass side has NO holes for a tailpipe hanger, I didn't expect any but I want to get one side correct before i start drilling...
thanks for any help here...
Last edited: