Search results

  1. Foxfan88

    installed fabricated box upper.

    got around to finally trying out the upper box i made for my setup. i was worried about it killing low end. but suprisingly the car feels the same down low. and it may have picked up top end i am not too sure, if it did its not a huge difference. i didnt take and exact measurements but i...
  2. Foxfan88

    speedo cable to VSS c clip??

    Anyone know where i can get a hold of the little metal clip that holds the speedo cable in the VSS??? i dont think its a shelf item, just seeing where some of you guys have gottem them/used in place of them. i'm sure alot of stang guys have lost it lol
  3. Foxfan88

    small video of my stang before the turbo

    got bored so i shot a small video of the stang. since i took my vortech off last fall ive been just tinkering around with tuning on the car to pass time whle i gather turbo parts. after lots of hours tuning i'm pleased with how the car runs. so soon i'll be fabbing up my turbo setup, i have...
  4. Foxfan88

    8.8 refreshen help

    heya guys i havent done much rearend work to my car. i am doing a turbo project over the winter on my car and have some 3.27 gears i am going to install. i am needing some links or part numbers for a gear install kit, i AM needing a new pinion seal and crush sleeve also i'd also like to...
  5. Foxfan88

    weather/rain screw up mech FP gauge??

    i have had some strange fuel pressure readings from my mechanical fuel pressure gauge. i have the gauge mounted on the backside of my cowl induction hood. originally when i put the mech gauge on, the FP readings were rock solid, then after a while the FP would start fluttering.... would...
  6. Foxfan88

    blower is off and going to build a turbo setup!

    this past week i took my supercharger setup off. have always wanted to do a turbo setup and i couldnt wait any longer. so i am back to N/A for the time being until i get my SC kit sold. plans are to build my own custom kit, i can weld and fabricate so it will be fun. i plan to use a...
  7. Foxfan88

    need a computer whiz!

    last week i dropped my laptop on the floor (about a 3' fall) computer was on (in the process of shutting down actually) the computer doesnt work right now. I am fairly sure the hard drive is toast. the computer will turn on and go the black screen that says COMPAQ in the center, and i...
  8. Foxfan88

    flucuating fuel pressure really bad.

    ok i have a mechanical FP gauge mounted in my cowl induction hood. was messing with the car today trying to solve soem cooling problems. hopped in the car to drive around and i noticed my fuel pressure was jumping around. the FP would hang around the correct pressure, around 39 psi, and...
  9. Foxfan88

    slight cooling issues and how to tell if fan clutch is bad?

    ok my car seems to run cool at 195ish, i currently have a 195 tstat installed. i do have a mech gauge so what i am seeing is accurate. cooling system is a stock replacement pump, replacement fan and clutch, OE shroud and stock radiator, AFAIK its the FACTORY radiator. never has given me...
  10. Foxfan88

    speedo cluster rebuild

    my brothers 91 lx has the crazy speedo problem going on, we replaced the cable and gear and it still acts crazy. it SORT OF reads accurate at very low speeds maybe 5-10 mph, after that it bounces all over the place. i have heard of getting the whole cluster rebuilt. or perhaps we could do it...
  11. Foxfan88

    got car running again! with vid

    was off all last week on paid vacation. put my new battery box and relocated battery, installed 255 lph pump and mounted up my ignition box, car ran awesome and then a few mins later a freeze plug popped out ( old ones rotted out and i replaced them with expandable plugs from under the car)...
  12. Foxfan88

    high compression on one cylinder?

    ok i'm in the process of taking my engine out for new freeze plugs and i was running a compression test as i was tearing her down to see how it was, since the engine got warm since all my water leaked out i was just making sure of any problems i may have. all cylinders had great compression...
  13. Foxfan88

    have to pull my motor now.... and suggestions on heads

    ok heres the story. my car has been running great but starts breaking up in the upper rpms due to stock ignition. i relocated my battery to the back and put my ign box up front close to the coil and etc. got it running today and opened my plug gap back to .035 took the car out, ran...
  14. Foxfan88

    blower belt slip??

    heya guys i threw a 2.90 blower pulley on.. ( was the stock 3.33) and along with my crank pulley (7") and it looks to be making about 10-11 psi on my combo i noticed that the boost gauge just slightly jumps around when it gets up in the higher boost levels. shakes a bit around 10-11 i'm...
  15. Foxfan88

    compression test results. should i be worried??

    been tinker on my car this weekend and last night it had a bad miss under high RPM. i suspected that it was the fact i am running the stock ignition i'm running on my combo. i pulled all the plugs to close to gap up to see if that would help etc so i figured i would run a compression test while...
  16. Foxfan88

    new vid of my car!

    been messing with the tweecer and tuning and tonight i hit the jackpot, i got the thing running really nice, cruises great and just flat out runs awesome compared to what it was. took a small vid, excuse the silly commentary but it beats typing lol. hoping to get it to run harder with some...
  17. Foxfan88

    my car now slips the clutch just romping on it. need suggestions

    yesterday me and a friend were tinkering and tuning my car out on some backroads. starting at 3k in 2nd, floored it, buried the tach spinning the tires, a hard shift to 3rd, buried the tach again spinning, a hard shift to 4th, buried the tach again. i thought to myself surely it couldnt...
  18. Foxfan88

    Nuetral safety switch help

    ok my car was originally an AOD car, i did a t5 swap and i left the NSS unhooked for a long time. my interior is out so i figured i would try to find it and hook it up. i found the NSS pigtail on my car but it doesnt match the NSS plug on my pedal assembly. i think the pedals came from an...
  19. Foxfan88

    location of eec power relay and ignition relay?

    i am in the process of some wiring work on my car and have the interior stipped out to make things easier. my FP relay is under the drivers seat and my MAF/o2 relay is near the passenger side shock tower. my papers and info i printed off say there is an ignition relay and EEC power relay...
  20. Foxfan88

    idle vid

    got bored and shot a vid the other day. let me know what you think. http://videos.streetfire.net/video/Idle-with-f-cam-and-blower_160859.htm car has been running for a few weeks, i got my tweecer and everything working but my o2s arent reading and i am suspecting there may be a wiring...
Top Bottom
Back
Forums
Menu