The kit will fit almost any turbo with a T-4 flange and a P-trim turbine. Anything else, and I just need to know so I can change the flange on the pipping. Turbonetics run a flat flange instead of the V-band I have on these.
The single kit still gets rid of the sway bar. I just need to make a header for the passenger side so you can run twins. Then Swaybar is OK. But it still doesn't fit the 65
. If these sell I want to make more headers for different years. It's just too expensive to do all at once when not making alot of them. I have to pay for setup, and them buy a minimum of 5 sets.
They will probably cost about 1250 for the headers, crossover and down pipe. I am selling them cheaper than that right now so I can move some of them and get "word of mouth."