Hey Guys. Well I finally finished my MS2 v3.0 kit, bench tested with my JimStim, installed it in the car and tested all I could. I got brave enough to try and start the car and low and behold it starts, if i open the throttle. It runs, it just won't idle on its own, in open loop. I have an AEM wideband O2 sensor with the analog output from the gauge input to the MS2, that works, car is running a bit rich, but thats better than lean. Anyhow, my big issue is getting the car to idle, i cant do much. I do have the PWM mod installed on the MS2. I have Tunerstudio MS and Megalogger HD. I wasn't sure where to start with a tune so i downloaded this tune from DIYAutotune MS2E v3.3.1a MSPNP2-EEC4B8 which is a PNP tune. I made a few changes to it under the Basic/Load setting tabs. I did invert the valve under Idle control tab and the car ran/idled at 2000 rpm, but it leaned out so I shut it off and put it back to normal.
the specs on my car/engine are:
1995 Mustang GT 5 speed 10.5:1 compression
FloTek aluminum heads 2.02" intake and 1.6" exhaust valves
Scorpion 1.6 roller rockers
BBK SSI intake and fuel rails
BBK 70mm throttle body
155lb/hr pump
Ford Racing #24 injectors
Ford TFI Ignition
MSD Blaster coil
And I'm sure I'm forgetting something
Anyhow, I will post my tune here, If anybody can get me going in the right direction, i would greatly appreciate it.
Thanks,
Paul
I should have said that it is OPEN LOOP that I cannot get it to idle in.
the specs on my car/engine are:
1995 Mustang GT 5 speed 10.5:1 compression
FloTek aluminum heads 2.02" intake and 1.6" exhaust valves
Scorpion 1.6 roller rockers
BBK SSI intake and fuel rails
BBK 70mm throttle body
155lb/hr pump
Ford Racing #24 injectors
Ford TFI Ignition
MSD Blaster coil
And I'm sure I'm forgetting something
Anyhow, I will post my tune here, If anybody can get me going in the right direction, i would greatly appreciate it.
Thanks,
Paul
I should have said that it is OPEN LOOP that I cannot get it to idle in.
Attachments
Last edited: