Quick throw out bearing help..Please

[Andy00018]

Hello, well I'm putting in my new throw out bearing I got with my KC clutch, being the dumbass I am, I forgot to check to see how it was in, dont know if its a big deal or not, but on the TOB, there is a sorta raised bump on the back part the cylinder. Does it matter whether it faces the clutch cable or the pivot?? Any fast advice would be great so I can knock this off of my to do list for my engine install on friday. Thanks

Also do I have to grease up the bearing retainer or will the grease already on the inside of the TOB be sufficient enough?

 

[Rick 91GT]

The bump keeps the bearing from spinning around, however the TOB must go in with the bearing surface towards the fingers on the PP. I like to put a small amount of grease on the fork where the bearing rides and on the pivot.