im seriousl thinkimg something came loose during thre install. check all the cables, hoses , and wires to the transmission.
I've mig welded on hundreds of cars with absolutely no ill effects, new, old, computer controller, etc. This is not your problem. Tig welding is a different story and I always disconnect the computers and pull them out of the car entirely before Tig Welding at all.
I may not have any other valuable input here, but Mig welding exhaust is not the problem.
Why do you think they make isolator tools for electronics when you weld on cars that have sesitive electronics. I seen first hand computer chips fri from just static and your telling me that if someone doesn't ground the mig at the right spot its not gona fry whatever small electrical things the current passes through. Hahaha
sounds like you are more qualified than us. good luck getting that soda bottle to jump out of the cup holder. Peace :drink:Oh and I was gm certified up until 2001 then went construction route cause it payed more
X2sounds like you are more qualified than us. good luck getting that soda bottle to jump out of the cup holder. Peace :drink:
Ha at 1st read I thought you were callin me namesthey do make the cup holder for the ash tray hole.