Installed the DCcontroller from dcconrtol.com today with the taurus electirc fan. Wired it up all correctly following the directions. But the fan doesnt seem to come on as the temp climbs, I let it get to just under 210 before shutting it off without the fan doing anything.
Did some troubleshooting, using 12V from the battery with a jumper on to the AC wire (blue), and the fan turns on, seems kind of slow but pulling some air at least. Then I tried adding 12V to the igition wire (yellow), using a jumper again, and the fan turns on, and seems to stay on regardless of the temperature.
I tried moving the temp probe to different parts of the rad, making sure it was sitting flush, and still nothing from the fan. ( I know its supposed to be by the outlet, I just moved it around for testing purposes.)
Any other ideas or suggestions? Faulty temp probe maybe?
Edit- Im pretty sure my thermo is just a stock 195* which I know doesnt match the controller, but after the thermo opens at 195 and the rad starts the flow it should trigger the controller to start the fan regardless shouldn't it?
Did some troubleshooting, using 12V from the battery with a jumper on to the AC wire (blue), and the fan turns on, seems kind of slow but pulling some air at least. Then I tried adding 12V to the igition wire (yellow), using a jumper again, and the fan turns on, and seems to stay on regardless of the temperature.
I tried moving the temp probe to different parts of the rad, making sure it was sitting flush, and still nothing from the fan. ( I know its supposed to be by the outlet, I just moved it around for testing purposes.)
Any other ideas or suggestions? Faulty temp probe maybe?
Edit- Im pretty sure my thermo is just a stock 195* which I know doesnt match the controller, but after the thermo opens at 195 and the rad starts the flow it should trigger the controller to start the fan regardless shouldn't it?